Page 1 of 2
quarterscale New Era Stadium truck
Posted: April 7th, 2022, 12:33 pm
by Jarhead2311
Re: quarterscale New Era Stadium truck
Posted: April 7th, 2022, 12:46 pm
by Jarhead2311
- IMG_5461.JPEG (22.08 KiB) Viewed 49308 times
Re: quarterscale New Era Stadium truck
Posted: April 7th, 2022, 2:56 pm
by Mike Casey
looks great! Nice custom arms.
Re: quarterscale New Era Stadium truck
Posted: April 8th, 2022, 3:42 am
by Kaye
What a beauty! Wonderful work!
Re: quarterscale New Era Stadium truck
Posted: April 8th, 2022, 3:48 am
by Kaye
Perfect tow vehicle for your Crackerbox rc boat!
Re: quarterscale New Era Stadium truck
Posted: April 8th, 2022, 12:00 pm
by Jarhead2311
Thanks everybody!! I was thinking the same thing. I just need a reverse transmission. Anyone know where I could get one.
Re: quarterscale New Era Stadium truck
Posted: March 21st, 2023, 10:42 am
by Jarhead2311
Re: quarterscale New Era Stadium truck
Posted: March 21st, 2023, 10:42 am
by Jarhead2311
Re: quarterscale New Era Stadium truck
Posted: March 21st, 2023, 1:44 pm
by Jarhead2311
- stadium truck hubs.jpg (23.32 KiB) Viewed 48941 times
Re: quarterscale New Era Stadium truck
Posted: March 21st, 2023, 1:44 pm
by Jarhead2311
- stadium engine.jpg (15.08 KiB) Viewed 48941 times
Re: quarterscale New Era Stadium truck
Posted: March 22nd, 2023, 12:03 pm
by Kaye
Those rims and tires will look great on the truck!
Re: quarterscale New Era Stadium truck
Posted: March 22nd, 2023, 12:23 pm
by Jarhead2311
the back ones on I had on the truck were 10" in diameter. They were just a little to big. The tires I'm getting are 8" in diameter which will fit the truck better i think
Re: quarterscale New Era Stadium truck
Posted: March 22nd, 2023, 12:51 pm
by Jarhead2311
- control arm.jpg (11.1 KiB) Viewed 48923 times
Re: quarterscale New Era Stadium truck
Posted: March 22nd, 2023, 12:51 pm
by Jarhead2311
you know anyone who has a control arm for the braking system
Re: quarterscale New Era Stadium truck
Posted: March 23rd, 2023, 4:03 am
by Kaye
Jarhead2311:
Unfortunately I don't know anyone who has one of these models. It may be possible to fabricate the control arm out of some aluminum flat bar, I'm guessing half inch or less. You'd need simple tools, which I'm sure you have, such as a drill press, reamer, saw, file(s).
Kaye